Loading... Please wait...

You Recently Viewed...

Polyzonal Indicator Keychain Radiation Detector

  • Polyzonal Indicator Keychain Radiation Detector
  • Polyzonal Indicator Keychain Radiation Detector
$120.00 (Fixed shipping cost)


The Polyzonal Indicator Key chain Radiation Detector is a radiation detector that detects EMF and microwave radiation above accepted levels.

The Polyzonal Indicator Radiation Detector is an Polyzonal indicator of infrasonic signals, electromagnetic fields (EMF) and microwave radiation that can detect and identify radiation above accepted standards, assessing their level and searching for point sources of radiation with relatively small capacity.

The Polyzonal Indicator Key chain Radiation Detector is equipped with a built-in economy LED flashlight. It is small in size and weight, providing long-term operation from just one battery.

Polyzonal Indicator Key chain Radiation Detector Main Characteristics:

  • Operating frequencies:
    • Infra-sound: 5-20Hz
    • EMF: 50-100kHz
    • UHF: 0.3-10GHz
  • Detection threshold:
    • Infra-sound: ~70dB
    • EMF: ~2mT
    • UHF: ~250mW/smІ
  • Dynamic range of input signals:
    • more than 40 dB
  • Structure of indication signals: pulses of 250ms and the cycle of 0,5s
  • Frequency of indication sound signal: 4kHz
  • Number of LED indicators: 4
  • Illuminating power of LED flashlight: from 0.2 to 2.0 cd
  • Power voltage: 2.5-3.3V
  • Current consumption / operating time:
    • No signal: 40μA/5000h
    • Light indication: 500μA/400h
    • Sound indication: 720μA/280h
  • LED flashlight: 800μA-8mA/250 2h
  • Dimensions: 48 x 32 x 12 mm
  • Weight (with battery): 16g


Operating the Polyzonal Indicator Key chain Radiation Detector:

Power Voltage Testing and Battery Replacement

At each powering the device check power supply status (CR2032 lithium battery) which is displayed on the indicator within 2 seconds by the corresponding number of discharge indicator levels.

With a battery fully charged there is one green and three yellow LEDs on, and while discharging they become less. Deep discharge is indicated by a red LED stating low battery capacity. Further operation is possible within no more than 100 hours.

To replace battery, remove the two screws as well as the cover of the product. Push the battery out of the retaining clamp and install the new one with the correct polarity (plus at the top). Turn the power on and make sure the battery is not discharged, as shown on the indicator. Turn off the power, put the cover back on and tighten the two screws. The product is ready for further use.

Note: The operational state of the product is confirmed by periodic short flashes of the right red LED once every 2.5s.

Detecting Radiation

The product provides two kinds of display when detecting and identifying radiation:

  • silent single pulses of the right red LED corresponding to UHF; single pulses of green LED corresponding to EMF and double pulses of green LED corresponding to infra-sound;
  • sound - additional intermittent signal with the frequency of 4 kHz. The sound when receiving can be temporarily disabled by briefly pressing the button until receiving has been completed.

To switch modes, you must briefly press, release, press again and hold the button. While this every 2 seconds the modes will switch periodically: silent (switches between green and red LEDs) and sound (signal 4 kHz). Release the button on the desired mode that will be saved up to the new installation.

When powering the device sets the mode previously selected.

This product ships from Russia UPS Express for $120.00 and takes less than 2 weeks to arrive.

Determining Power and Location of Source

When receiving three yellow and the left red LED lights show signal level in decibels relative to the accepted standards (dBs). For instance the level of 40dBs (all LEDs on) shows excess rate of 10,000 times in terms of power.

The product allows you to determine the location of radiation according to the growing number of yellow and left red LEDs enabled as approaching it.

Use of LED flashlight To activate flashlight, press and hold the button until LED is on the end of the case. Further holding the button leads to triple increase in brightness up to the maximum for 4s. Release the button at the desired brightness. To turn off the flashlight push the button shortly.

Polyzonal Indicator Radiation Detector Specifications:

Height 48 mm
Width 32 mm
Thickness 12 mm
Weight 16 g
Case Plastic
Power supply Battery

Download the manual for the Polyzonal Indicator Radiation Detector.

Warranty Information

EyeSpyPro guarantees this product for 90 days from date of purchase. If the manufacturer offers a longer warranty, we will assist you in obtaining repairs under warranty. Contact us for the manufacturers warranty for this product.

Find Similar Products by Category

Click For EyeSpyPro on Facebook Click For EyeSpyPro on YouTube Click For EyeSpyPro on Google+ Click For EyeSpyPro on Pinterest Click For EyeSpyPro on LinkedIn Click For EyeSpyPro on Vimeo Click For EyeSpyPro on Twitter Click For EyeSpyPro on Stumble Upon Click For EyeSpyPro on Ezinearticles.com

EyeSpyPro.com 101 S. Coit Rd., Suite 36-235, Richardson, TX 75080 USA
Phone: 1-949-791-7904 - FAX: 1-800-862-6120

All clients who purchase from this website agree to all terms and conditions in our Shipping, Returns/Cancellations, Payments, and Warranty links above.

With thousands of products, and dozens of suppliers, there is no guarantee your product will be in stock when you order it, so if its critical you need it right away, please call us @ 1-949-791-7904 before you make your order to confirm it is available and not out of stock or backordered.

Make sure you call us if you have any questions about selecting the correct product to fit your needs before you order, as any custom built hidden cameras, open software or fluid detection devices, boxes with the seal broken, vehicle trackers, and bug detectors are not refundable or returnable unless defective. We are here to assist you, and if you have ANY questions, please call us before you order @ 1-949-791-7904.

30 Day Satisfaction Guarantee: If for any reason you are unhappy with your purchase, you may return it for an exchange or a credit towards any other product within 30 Days,
no questions asked. In order to provide you with high quality products, we do not issue any refunds unless the product arrives defective.

Not responsible for typographical or illustrative errors. Prices, specifications, and images are subject to change without notice.

EyeSpyPro is not responsible for any shipment that is seized by any Government Customs or Border Protection Agency. We are not responsible for any duties, import fees, taxes, VAT charges, or any other fee that you are charged to ship it to you.

Any camera that is not advertised as a day/night, low light, or low lux camera will not perform well in low light, and not at all in the dark. Make sure you know what you are ordering before you order it, and feel free to call us @ the number above or send us an email using the Contact link above.

Do not buy any infrared illuminator if your camera is not an IR camera. It has to have a removable IR-Cut filter that slides out of the way at night for the camera to recognize the IR.

Shipping prices are for one small item. If you order more than one small item, including complete systems, we will adjust the order and charge the actual shipping price.

EyeSpyPro.com does not endorse any of our products for illegal activities. EyeSpyPro.com is not responsible or liable in any way for any damage, vandalism, theft, or any other action that may occur while a EyeSpyPro.com product is in use by the purchaser.